Spaz
12-13-2003, 08:24 AM
Greetings everyone;
I've been doing some novice editing on my PC (AMD 200+, 1.66GHz, 224RAM) with Premiere 6. My wife was nice enough to get me a Powerbook G3 266 Wallstreet for both my birthday and my introduction to the world of Mac.
I am looking at upgrading the PB with a new processor (Bluechip or Crescendo), maxing out the RAM to 512, adding a 32 GB HD and installing an external Ratoc Firewire (with the possiblity of adding an external 250 GB HD for a scratch disc). I would like to run FCP 3 for my NLE.
I am hoping to move up the prosumer level eventually and I am just wondering if this is a good start or if should just save up my pennies, cut to the chase and get the G5.
Any advice, configuration/hardware/software suggestions would be very much appreciated.
L8er dayz, Spaz
I've been doing some novice editing on my PC (AMD 200+, 1.66GHz, 224RAM) with Premiere 6. My wife was nice enough to get me a Powerbook G3 266 Wallstreet for both my birthday and my introduction to the world of Mac.
I am looking at upgrading the PB with a new processor (Bluechip or Crescendo), maxing out the RAM to 512, adding a 32 GB HD and installing an external Ratoc Firewire (with the possiblity of adding an external 250 GB HD for a scratch disc). I would like to run FCP 3 for my NLE.
I am hoping to move up the prosumer level eventually and I am just wondering if this is a good start or if should just save up my pennies, cut to the chase and get the G5.
Any advice, configuration/hardware/software suggestions would be very much appreciated.
L8er dayz, Spaz